The IMU-3000 Evaluation Board does not specifies what are pins 1, 2 and 3 of the JP1 and JP2. This is necessary to know were to connect the jumpers to select the internal regulator or to connect directly to Vcc. The labels printed on the EVB are as follow:
x -> pins
V_Logic Sel.
x IO_VDD M2
x
x VDD M4
JP1
VDD Sel.
x Vcc_I M6
x
x 3VO M5
JP2
This is not consistent with the Assembly Drawing of the EVB from page 9 of the IMU-3000 EVB Datasheet. This datasheet has the following:
V_Logic Sel.
x VDD_IO M2
x
x 3VO M4
JP1
VDD Sel.
x 3VO M5
x
x VCC M6
JP2
Right now im not able to communicate with the device through I2C with a MSP430F2471.. Can you guys specify wich are pins 1, 2 and 3 of both JP1 and JP2?
- Log in to post comments
phpbb Topic ID
13917