case for the MotionFit sensor

By tchsu , 3 January 2013
Forums
SmartMotion® MEMS Motion Sensors

Hi,
any suggestions for a casa for the sensor? Does a case for it exist already, where it is possible to have access to the on/off switch, so that the sensor can be used without being put out of the case?

Thank you

stueckrath.c

13 years 2 months ago

I cut holes in a Polycase KT-35 to access buttons, switch, and charging port. I put a .25 in long light pipe in to still see the LED blink. It's a little bigger than necessary. Perhaps you could find something similar. InvenSense suggests using an ipod nano wrist strap, but it doesn't completely protect the board and you have to take the board out to operate switch and charge as far as I know

phpbb Post ID
22242
phpbb Topic ID
14952