pycube and actual SDK

By launcher , 18 September 2014
Forums
SmartMotion® MEMS Motion Sensors

Hello all,

I have just bought a CA-SDK board for the MPU-9250 and encountered a few issues -

1. The pycube on the screen does not physically match the orientation etc. of the board. Is this normal?

2. Even if I keep the board on a stable surface, I keep getting no motion! motion! in progression. What could be the issue/solution to this?

Thank you for your help.

Regards,

KS

guy_mcilroy

11 years 5 months ago

You need to calibrate the device by running self test, when the device is kept idle, it pushes itself into low power mode and can be woke up by motion interrupt. This motion interrupt depends on the thresholds being set to wake up. Default value from the motion driver code is 500mG.

phpbb Post ID
25869
phpbb Topic ID
16626