I recently purchased an EV_ICM-42688-P board from Mouser but it arrived without any technical documentation.
Please provide a link to an accurate and readable PDF schematic. Also any applicable Appnote if available.
- Log in to post comments
phpbb Topic ID
45760
Hello,
Please check the links below:
https://invensense.tdk.com/products/motion-tracking/6-axis/icm-42688-p/
https://invensense.tdk.com/products/dk-42688-p/
Thanks for your reply but I was hoping for the URL of an updated version of the 'InvenSense Motion Sensor Universal Evaluation Board (UEVB) User Guide' (See attached, UEVB Schematic Figure 3 ).
AN-000300, 'SmartMotion Development Platform (Ver. G)', page-14 Schematic Figure 7, 'Sensors, DB and EVB connectors', does show a 20-pin 'EVB Connector', labeled CN1, that appears to be a superset of the stenciled pin lables on my EV_ICM-42688-P board. The VIN voltage of my EV_ICM-42688-P connector would correspond with pin 19 of CN1 which is labeled 'VCC_P5V0'. Thus I am concluding VIN of EV_ICM-42688-P == VCC_P5V0 of DK-42688-P.
No where contained in AN-000300 is the 'EV_ICM-42688-P' board mentioned so I am uncertain if CN1 is intended to connect with an EV_ICM-42688-P board.
Also the schematics of the DK-42688-P do not show the power source of VCC_P5V0, so I am assuming the value of VCC_P5V0 is 5V based on the naming convention.
Is it safe to assume I can apply 5V to the VIN , pin 19, of the EV_ICM-42688-P?
Again I am requesting a user guide and a schematic of the EV_ICM-42688-P if you have one.
Hello,
App Note is going to be released for the EV_ICM-42688-P soon. I can share you the Connector and Jumper reference.